46
RollCall Control Panel
Link Control
Link Control
The
Link Control
page allows 4K spigots to be configured. Input/output can be via single or
quad link. See
on page 28 for information on selecting the required input/
output configuration.
Link Control page
UHD Links
Enable the spigots to be used as required. Note that these controls are not available when
using a single connector to carry 12G.
Disable SDI Sync Bit
: some older SDI receiving equipment may not support sync bit insertion.
When transmitting signals to these devices, sync bit insertion can be disabled by checking the
boxes as required.
TPG
These controls are displayed only when using 12G output.
SDQS
: If using Square Division signals, enable the
SDQS
check boxes as required. Otherwise,
Two-sample Interleave will be used.
UHD ST352 Insertion
: set the ST352 ancillary data type according to how the TPG data is to be
output.
• For ST2082-10 output over a single link, select
12G Single Link
from the drop-down list.
• For ST425 output over quad links, select
12G Quad Link
from the drop-down list.
See
SMPTE 2082: 12G-SDI Bit-Serial Interfaces
,
SMPTE 425: Bit-Serial Interfaces at 3 Gb/s
and
SMPTE
352: Payload Identification Codes For Serial Digital Interfaces
for further information.
Summary of Contents for Kudos Pro LC4000
Page 14: ...xiv Notices ...
Page 22: ...22 Connections Cabling ...
Page 24: ...24 Card Edge LEDs ...
