28
Operation
Remote Control Using iControl
** Parameters shown here in braces { } will display the actual value of the item and not the text shown above.
** Parameters shown here in braces { } will display the actual value of the item and not the text shown above.
*** The Kaleido-MX does not support converting an input module into a 4K UHD prescaler. The SFP ports
are not yet supported.
Remote Control Using iControl
The Kaleido-MX may be controlled by using Grass Valley’s iControl version 4.43 or later. This
section describes the two control panels associated with the Kaleido-MX’s input and output
cards and their use. Refer to the iControl User’s Guide for information about setting up and
operating iControl.
In iControl Navigator, iControl Web, or iControl Solo, double-click the icon for a Kaleido-MX
input or output card (KMX-3901-OUT, KMX-3901-IN-8-D, KMX-3901-IN-16-D, or KMX-3901-
IN-16-Q) to open the associated control panel.
Kaleido-MX Service Control Panels in iControl
The card label (
KMX-IN-16-D,
and
KMX-OUT
in the examples below) and the slot number
where the card is installed in the Densité frame are indicated in the window’s title bar.
The service control panel for Kaleido-MX input cards only offers information.
Kaleido-MX input card local menu
STATUS
CARD STATUS
{CARD STATUS}**
INPUT STATUS
1 {FORMAT}**
2 {FORMAT}**
3 {FORMAT}**
16 {FORMAT}**
CONFIG***
4K UHD PRESCALER ENABLE
DISABLE
SFP CONFIG
SFP OUT 1
ON
OFF
SFP OUT 2
ON
OFF
SFP OUT 3
ON
OFF
SFP OUT 4
ON
OFF
{CARD VERSION}**
...
