GRASS VALLEY K2 SAN, Installation And Service Manual

Page: 68 / 346

in the network path, you must make sure that no restrictions are in place that block SiteConfig
protocols.
Also, do not install SiteConfig on a PC on which a drive from a managed device is mapped as an
administrative share (C$). For example, if you have a PC set up to run anti-virus software and for
this purpose you have network drives set up on the PC mapped to C$ shares on devices, then do not
use that PC to host SiteConfig and manage those devices.
For a given system, there should be just one instance of SiteConfig managing the system.
System requirements for SiteConfig host PC
The PC on which SiteConfig is installed must meet the following requirements:
Comments Requirements
Microsoft Windows (Must be a U.S. version):
• XP Professional Service Pack 3
• Server 2003
• Vista Enterprise Service Pack 1
• Windows 7
• Server 2008 R2
Operating system
Minimum 512 MB, 1 GB recommended RAM
Must have at least 128 MB memory Graphics acceleration
Pentium 4 or higher class, 2 GHz or greater Processor
400 MB Hard disk space
Version 4.0 Microsoft .NET Framework
1.3.1_12 and 1.4.2_05 or higher. Required for
the HP Ethernet Switch configuration interface,
which is used for K2 SANs. Java JRE
Microsoft XML 4 Service Pack 2 is required. XML
Installing/upgrading SiteConfig
Prerequisites:
• The PC on which you are installing SiteConfg meets system requirements.
• The PC is connected to the LAN on which all the devices to be managed are connected.
• There are no routed paths to the devices to be managed.
1. Procure SiteConfig installation files from the Grass Valley website or via other distribution
mechanisms.
The following directory and files are required to install SiteConfig:
•
DotNetFx
directory
•
ProductFrameUISetup.msi
•
setup.exe
68 K2 SAN Installation and Service Manual 2014 01 27
Setting up the K2 SAN infrastructure