GRASS VALLEY JUPITER CONTROL PANEL L32 -, Instruction Manual

Page: 136 / 216

136 JUPITER L-S and LCD Series Control Panel Instruction Manual
Section 6 — L-S Series Panel Operation
3. Use the Category buttons to enter the number of that Destination.
Alternatively, you can use the Selector knob to scroll through the
available Destinations. If the entry is valid, the name of the Source will
appear in the Preset window in yellow, and the category/number for
the Source will be shown in blue.
4.
When the desired Destination is displayed, press
Select
.
Selecting a Source
Note If a Destination has been Protected or Locked by another panel, the Protect/
Lock button will illuminate steady amber (Protect) or red (Lock) and the Des-
tination will not be able to be switched. To continue, the Destination must be
unprotected or unlocked by the panel that set the protect or lock (the name
of that other panel will be displayed in the menu).
CAUTION If the Select button is blinking, Sources will switch as the knob is turned (see
Scroll Take Mode on page 141 ). Make sure Scroll Take is OFF before selecting
Sources with the following methods.
Selector Knob Method
1. If necessary, press
Clear
to take the panel to its home state.
2.
Use the selector knob to scroll through the available Sources displayed
in the Preset window.
3.
When the desired Source is selected, press
Take
. That Source will be
switched to the currently controlled Destination.
Category Button Method
If your Jupiter system and panel has been configured with categories you
will be able to use the 16 Category buttons on the right to select Sources.
1.
If necessary, press
Clear
to take the panel to its home state.
2. Press one of the 16 Category buttons on the right to select the desired
category (VTR, for example). The Category buttons then shift to
number selection mode.
3.
Use the Category buttons to enter the number of that Destination.
Alternatively, you can use the Selector knob to scroll through the
available Destinations.
4. When the desired Source is selected, press
Take
. That Source will be
switched to the currently controlled Destination.