GRASS VALLEY JUPITER CONTROL PANEL L32 -, Instruction Manual

Page: 128 / 216

128 JUPITER L-S and LCD Series Control Panel Instruction Manual
Section 6 — L-S Series Panel Operation
in which the overrides are listed on the CP Override set table will be the
order in which they appear on the panel.
To Execute an Override
1. Select the desired Destination.
2.
Press
Override
. The D1window will display
Select Override
. The display
windows will indicate available overrides. To scroll to additional
override groups, use the
Up/Down
arrow buttons.
3. Press the soft button next to the desired override.
4.
To execute the override switch, press
Take
. The Sources on the levels
specified in the override will be switched to the Destination.
Sequence (Salvo) Switching on an LD16 Panel
Pre-built Jupiter sequences can be executed after they have been created
and downloaded (see
Setting Up a Salvo with a Sequence Set on page 63 ).
1. Press the Seq button. Sequences will appear in groups of 16, in white, in
the display windows. Use the
Up/Down
arrow buttons to scroll to the
additional sequences.
• If the
Seq
button does not illuminate, there may not be any
sequences defined to this panel.
2. Press the soft key for the desired sequence. The number of the preset
sequence will appear in the D16 window.
3. Press
Take
to execute the sequence.
Front-Panel Service Modes
These modes are provided for panel maintenance and troubleshooting.
They are not normally used by the operator.
• Panel Info Mode is described on page 183 .
• Panel Setup Mode is described on page 185 .