GRASS VALLEY IQUCP25, User Manual

Page: 31 / 338

31
UCP - 3901
User Manual
Installation
Getting Organized / Unpacking
Make sure the following items have been shipped with your UCP - 3901 order. If any of these
are missing, contact your distributor or Grass Valley (see Grass Valley Technical Support , on
page 338).
Your UCP
- 3901 package includes the following:
• UCP - 3901 Card (front and rear modules), as per order
• SFP modules, as per order
Required Tools
In addition to the above, you will need the following tools (field supplied):
• Phillips #2 screwdriver to remove and install rear panels
Required Material
In addition to the above, you will need the following (field supplied):
• Client PC
• Optionally for a multiviewer, display cables /converter (to connect your multiviewer to
displays)
• At least one Densité frame with available modular card slots
• Ethernet network connectivity
Installation of the Rear Connector Panel and Card
Grass Valley Densité series cards are each associated with a rear connector panel, which
must be installed in the Densité frame before the card can be inserted.
The UCP
- 3901 card is designed to fit into Grass Valley’s Densité-3 or Densité-3+ frame. See
UCP - 3901 Ordering Information , on page 21 for details about the cards and rear panels that
are available.
See
Rear Panel and Connectors , on page 32 for details of the signal connections available
on a rear panel.
All cards and rear panels can be installed with the frame power on. The card has connectors
which plug into a mid-frame mother board for distribution of power and for connection to
the controller card, and a second connector which plugs directly into the rear connector
panel for input and output.
The rear connector panel must be installed with the card out of the frame.
• To remove an existing card from the slot, tilt up the swivel handle on the front of the
card to lever the connectors apart, then use the handle to pull the card straight out of
the slot.