29
Configuring the DMR 1000
The DMR 1000 ships with default configuration settings. In general, you can leave most
configuration settings at their default values. However, there are a few settings that you
must configure.
This page and the next provide two sample configurations: analog SD and digital HD.
A list of all the possible configuration settings begins
.
Sample Analog SD configuration
If a configuration setting is not specified, you may leave it at the default setting.
Setting
Path
Value
Audio input
Set on the back of the DMR
)
Audio channels
Audio | channels | channel <1-4>
analog source 1-4 (set all 4 channels)
Video standard
a
a. Make sure to eject any loaded clip before setting the video standard. If the DMR is playing, recording, or has a clip loaded,
the video standard setting is unavailable.
Setup | formats | video standard
Select one of the following:
480i59
576i50
Video source
Setup | formats | video source
CVBS (composite)
b
b. Selecting the Composite Input disables the Reference input.
Media selection
Setup | formats | media selection
Specify REV, one of the CF disk drives, or an external source
Run mode
Setup | Timecode | run mode
Free-run
Play mode
Setup | Timecode | play mode
From file
Input type
Setup | Timecode | setup | input
type
DVITC
Drop frame (if
NTSC)
Setup | Timecode |Setup |
dropframe
DF
F-run sync
Setup | Timecode |setup | f-run
sync
External
DVITC
Setup | Timecode | setup | DVITC
14
ATC SD (ignore
if using HD)
Setup | Timecode | setup ATC SD
11
6
