GRASS VALLEY GV K-FRAME XP, Installation Planning Manual

Page: 54 / 87

System Cabling
54
Kayenne Satellite Panel Cabling
mapped, but this order matches the default configuration. The table below shows the
connections for various Kayenne Control Panel models used in a single suite.
PCU Port to Control Panel Stripe Connections, Single Suite
Control Panel Model PCU Port Panel Stripe
4-M/E with Local Aux 1 M/E 1 (top Stripe)
2 M/E 2 (second Stripe)
3 M/E 3 (third Stripe)
4 M/E 4 (bottom Stripe)
5 Local Aux Stripe
3-M/E with Local Aux 1 M/E 1 (top Stripe)
2 M/E 2 (second Stripe)
3 M/E 3 (bottom Stripe)
4 Local Aux Stripe
2-M/E with Local Aux 1 M/E 1 (top Stripe)
2 M/E 2 (bottom Stripe)
3 Local Aux Stripe
1-M/E (without Local Aux) 2 Master E-MEM, MFM (top tray)
1 M/E (bottom tray)
Kayenne Satellite Panel Cabling
PCU Cabling
Each Satellite Panel has a standard multi-pin cable for connection to the PCU. Modules
independent of a particular Stripe (for example Device Control or Master E-MEM modules)
can use any available PCU connector.
Modules to be associated with a particular Stripe (like a Transition Module) must be
connected to the next higher PCU port for that Stripe. For example, if you wish to use a
Transition Module with M/E 4 that uses PCU Port 4, plug the Satellite Panel into PCU Port 5,
and move the Local Aux Stripe connector (if used) to PCU Port 6.
Internal Cabling
The RJ-45 connectors inside the Satellite Panel trays are used for proprietary
communications only. Ethernet devices may be damaged if plugged into these connectors.
CAUTION: Do not connect or disconnect multi-pin PCU cables while the
PCU is powered up. Damage to the equipment can result.
CAUTION:
The RJ-45 connectors inside the Satellite Panel trays are used
for proprietary communications only. Ethernet devices may
be damaged if plugged into these connectors.