13
2. Setting Tool Conditions [CONDITION]
Advanced Control of Tool Behavior
Make advanced tool condition settings based on the property of the media that you use.
CAUTION
• For the setting of cut line pattern, normally use the default value of off.
• Use Tool Holder 2 when cutting with any perforation pattern (aside from turning it off).Unlike
normal media cutting (half cutting), cutting with a perforated pattern (cutting out) will damage the
cutting mat and may affect the quality of normal cutting. Therefore, do not use Tool 1 for cutting
with a perforated pattern.
• A fee will be charged for replacement of the cutting mat that is damaged by the use of Tool 1 for
cutting with a perforated pattern.
• For more information about installing the tool, see the "2.2 Attaching a Tool" in the CE6000
User's Manual.
1
Distance Adjust
Adjust the difference between the data and the line of actual cutting
or plotting that occurs due to the material or thickness of the media.
In the vertical axis (Y) and the horizontal axis (X) respectively,
specify the percentage to use for the adjustment.
Off
Adjustment is not performed.
On
Adjustment is performed.
Setting range -2.00 to +2.00%
2
Tangential Mode
Use this function to cut media whose thickness is equal to or greater
than 0.3 mm (0.012 inch).
Off/Mode1/Mode2: What is Tangential Mode (page 14)
Setting range [Overcut (Start, End)] 0.0 to 0.9 mm (0.0 to 0.035 inch)
[Initial Down Force] 0 to 20
3
Cut Line Pattern
Specify whether to perform full line or dashed (perforated) line
cutting.
Cut Line Pattern (page 14)
Off
Full line cutting is performed.
On
Dashed (perforated) line cutting is performed.
When setting to On, you can either select a pattern
from 0 to 7 or set an arbitrary pattern (User) or (None).
4
Simple
Hides advanced setting items.
1
2
3
4