2 1
5. Setting Area Parameters [AREA]
CAUTION
· Although plotting can be performed at a position on and outside of the push rollers when the expand limit is
set to a positive value in [Set Expand Limit] under [Expand], some media may not be fed properly because
the push rollers move on the plotted surface.
· When the expand limit is set to +8 mm or higher, Initial may be performed outside the loaded media,
regardless the setting in [Initial Blade] in the [Tools Setting] screen (
¨
page 18) In this case, caution is
required because the blade may be damaged.
1
Scale
Opens the [Scale] screen.
¨
Scale Setting (page 21)
2
Mirror
Opens the [Mirror] screen.
¨
Mirror Setting (page 21)
3
Expand
Opens the [Expand] screen.
¨
Expand Setting (page 22)
4
Area
Opens the [Area] screen.
¨
Area Setting (page 22)
5
Close
Closes the [Area Parameters] screen.
In the main screen (
¨
page 9), click
[AREA] to open the [Area Parameters] screen.
In the [Area Parameters] screen, you set values regarding to the plotting area.
Reference
· When turning mirror mode on or off, the Area settings are initialized.
· You should set a Expand setting before sending the plotting data to the plotter, When you change the setting,
the plotter clears data in the buffer memory to perform initial settings.
· In [Area], set the values in [Set Upper Right] and [Set Lower Left] so that the distance between them is equal
to or larger than 5 mm.
Scale Setting
Plotting is performed with the enlarged/shrunk size.
Scales that can be set are 1/8, 1/4, 1/2, 1, 2, 3, 4, 5, 6, 7, and 8 (multiplications).
Mirror Setting
Sets the mirror mode that reverses the origin point and vertical and horizontal coordinate axes.
Selecting On enables the mirror mode.
When the plotter power is turned off, the mirror mode is also turned off.
3
4
1
2
5
