LCX603-UM-651-9370
2-68
2 Setup
2.19 Adjusting the print head position
This adjustment should be performed after the distance adjustment.
Head position adjustment occurs depending on the type and thickness of the utilized media, and the
head (ribbon) position misalignment is corrected. The head position adjustment value is entered as a
measurement of the line segment misalignment.
The adjustment pattern is printed, and the correction value is entered in the head position adjustment.
The adjustment pattern outputs two layers. Measure the first layer and input the correction value for
Head 1 Position Adjustment. Measure the second layer and input the correction value for Head 2 Position
Adjustment.
The 130 mm width media have to be installed when performing the print heads position adjustment.
And the ink ribbons have to be installed for all print heads.
Adjustment Pattern Instructions
Y
X
First page
Second page
Y
X
Printed with head 3
Printed with head 3
Printed with head 2
Printed with head 1
Feeding direction
Feeding direction
Wrinkle
prevention
lines
Wrinkle
prevention
lines
Measure the gap between cross mark to the vertical line.
And measure the gap between cross mark to horizontal line.
Measure the gap between cross mark to the vertical line.
And measure the gap between cross mark to horizontal line.
Summary of Contents for LABELROBO LCX603
Page 2: ......
