4-37
CHAPTER 4 Settings and Measurement
(5) Set the stealth.
When this is set, the SSID cannot be searched from other terminals. Enter the SSID name directly on the
device to be connected.
(6) After completing the above settings, press the "Execute" button to execute "Apply settings".
The settings are saved.
(5)-3 TCP-IP settings
This is the setting for connecting the GLT400 via TCP/IP.
In the Access point, only the IP address, port number and non-communication disconnection can be set.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
<Wired LAN and Wireless LAN Stations>
< Wireless LAN Access point>
(2)
(3)
(4)
(7)
(8)
Selection item
Description
(1) IP Address Auto Acquisition
Set whether the IP address should be manually set or automatically acquired.
* If auto acquisition is enabled, the auto acquisition operation (performed when the power is
turned on or the settings are reflected) may take a few seconds to around one minute.
(2) IP Address
Sets the IP address of the GLT400. (0-255.0-255.0-255.0-255)
(3) Subnet Mask
Sets the subnet mask of the GLT400. (0-255.0-255.0-255.0-255)
(4) Port Number
Sets the IP port number of the GLT400 (1024-65535).
(5) Gateway
Sets the gateway address of the GLT400. (0-255.0-255.0-255.0-255)
(6) DNS Address
Sets the DNS address of the GLT400. (0-255.0-255.0-255.0-255)
(7) Keep Alive
Used to set the function to detect the non-communication time and automatically disconnect
the socket connection.
For details, refer to "Keep Alive".
(8) Reflect Settings
Reflects the TCP-IP settings immediately (without turning off and on the power).
* Connections are forcibly disconnected when the settings are reflected.
* Reflecting the settings may take a few seconds to around one minute.
● During IP Address Auto Acquisition, the LAN LED (when wired LAN is used) or SD ACCESS LED (when
wireless LAN is used) flashes at 1-second intervals. If the flashing does not disappear, the IP address has
not been acquired properly. Set "IP Address Auto Acquisition" to "Not used" and then set the IP address
manually.
● When the wired LAN setting was changed, turn the power off and then on again, or apply the settings. (The
socket connection is forcibly disconnected.)
● When you want to use the IP Address Auto Acquisition function, the DHCP server must be operating
separately within the searchable network.
