4-26
CHAPTER 4 Settings and Measurement
(3)-6 Backup setting
The GLT400 has a function that periodically backs up captured data.
(See the figure below)
(1)
(2)
(3)
Setting
Description
(1) Backup Intervals
Sets the backup interval for captured data.
Off, 1, 2, 6, 12, 24 hours, or Off, By file
* “By file” can be set under the following conditions.
• Backup destination is "FTP"
• "Recorded file when backup is successful" in the FTP Client Setting is set to "Delete".
(2) Backup Destination
Sets the backup destination for captured data.
Refer to “FTP Client Settings” in “(5)-5 Other settings”.
Internal
memory
Backs up the captured data to the internal memory.
This is used only when capturing to the SD CARD.
SD CARD
Backs up the captured data to the SD CARD.
This is used only when capturing to the internal memory.
FTP
Backs up data to an FTP server on the network.
*The FTP server settings must be made using the FILE menu.
(Refer to "FTP Server Settings" in "(5)-5 Other settings".)
(3) Save Folder
Sets the folder for saving a backup file.
* This must be a folder on the internal memory, SD CARD or an FTP server.
Example: \BACKUP\20200201
Captured data
Backup data
Backup interval
Capturing start
Capturing stop
Backup interval
Backup interval
Backup interval
Backup 1
Backup 2
Backup 3
Backup 4
Backup 5
● If ring capture is On, the backup function is not available.
● It takes a time for writing after capturing was stopped when many channels are captured, when interval
sampling is fast, when backup interval is long, because the backup data size becomes large.
● Sometimes the backup will be failed when the backup data is saved to the FTP server via the wireless LAN
by condition of Wifi communication.
● When the sampling interval is faster than the 100 ms the backup of CSV format is not able to perform.
● When the capture in CSV format and backup function are enabled, SD CARD replacement for capturing
and Relay capturing cannot be performed.
● When the external sampling function is ON the backup function is not able to perform.
● The media cannot be replaced when saving to an FTP server.
● When using trigger repeat, the repeat interval may become long because the next capturing is started
after the backup writing is completed.