GRAPHTEC GL980, User Manual

Page: 152 / 202

3-108
CHAPTER 3 Settings and Measurement
(5)-3 TCP/IP advanced settings
(1)
(5)
(2)
(6)
(3)
(7)
(4)
(8)
Setting Description
(1) IPAddr Auto Acq. Set the IP address automatic acquisition.
On, Off
(2) IP Address Set the IP address.
0 to 255 . 0 to 255 . 0 to 255 . 0 to 255
* When the IP address is set automatically, the automatic set IP address is displayed.
(3) Sub-net mask Set the subnet mask.
0 to 255 . 0 to 255 . 0 to 255 . 0 to 255
* When the IP address is set automatically, the automatic set sub-net mask is displayed.
(4) Port number Set the port number of the control command server.
1024 to 65535
* This is the port number specified when connecting to our application (GL980-2000_APS).
(5) Gateway Set the gateway.
0 to 255.0 to 255.0 to 255.0 to 255
※ When IP address is set automatically, the automatic set gateway address is displayed.
(6) DNS address Set the address of the DNS server.
0 to 255 . 0 to 255 . 0 to 255 . 0 to 255
* When the IP address is set automatically, the automatic set DNS server address is
displayed.
(7) Keep Alive Set forced disconnection time when no communication is detected by the control command
server.
Off, 10 seconds, 30 seconds, 1 minute, 10 minutes, 30 minutes, 1 hour
If no communication state continues for specified time or more, the socket connection is
disconnected. You should generate a communication within the set time. When using the
supplied application software, note that it will be the non-communication state while the
captured data is being replaying.
(This function is available only for the control command server, and does not affect the Web
server function and FTP server function.)
(8) Apply Settings Confirm TCP/IP setting and restart TCP/IP processing.
•
If the Automatic IP Address Acquisition fails (see the figure below), the IP address is not set properly.
Disable the Auto IP Address Acquisition and make the settings one by one .
•
After you have changed the TCP-IP settings, turn off and turn on the power, or execute Reflect Settings (The
connection will force disconnect) .
•
When you want to use the IP address automatic acquisition function, DHCP server must be operating
separately within the searchable network .
< Auto IP Address Acquisition is successful > < Auto IP Address Acquisition fails >