GRAPHTEC FC2250 Series, User Manual

Page: 99 / 130

5-23
Chapter 5 FUNCTION SETTINGS AND OPERATIONS
5.21 Setting the Step Pass
Use ths functon when you ntend to cut extremely detaled data. The cuttng data sent from the computer
will be processed in blocks corresponding to the number of steps specified by the STEP PASS function,
thereby ensurng consstent blade control and hgher cuttng qualty.
(1) Press the [PAUSE] key to select PAUSE mode.
(2) Press the [NEXT] key repeatedly untl the followng menu s dsplayed.
FORCE OFFSET
SPEED QUALITY
OPTION1 OPTION2
(3) Press the [F2] key (OPTION1) to dsplay the menu shown below.
FORCE OFFSET
SPEED QUALITY
START FCE OFST ANG
OFST FCE STP PASS
(4) Press the [F4] key (STP PASS) to dsplay the step pass settng screen.
FORCE OFFSET
SPEED QUALITY
STEP PASS
STEP PASS = 1
Use the [ ] or [ ] key to change the numerc value, and then press the [ENTER] key to confirm your selection.
Setting range: 0 to 20 [Default value: 1]
1 0 2 18 19 20
If the STEP PASS settng s set too hgh, the cut shapes may become deformed. The recommended STEP PASS
settng s "STEP PASS= 1".
(5) Press the [PAUSE] key to cancel PAUSE mode.
This setting is retained in the plotter's internal memory even while the plotter is turned off.