GRAPHTEC CUTTING PRO FC2250-120ES, Service Manual

Page: 100 / 210

FC2250-UM-251-9370 7-52
7. DISASSEMBLY AND ADJUSTMENT
7.5.8 Preparing the Y Flexible Cable Assembly
Assemble the Y flexible cable assembly if you have the Y flexible cable (PN:162291101) and the Y flexible
cable reinforcement (PN:022904331) separately.
You don’t need to assemble if you have the Y flexible cable assembly (PN:772258520).
How to assemble the Y flexible cable assembly
(1) Prepare following size of the double-sided adhesive tapes. And affix those pieces of double-sided
adhesive tape to the flexible cable and the flexible cable guide as shown in figure below.
(2) Write down the connector number at the end of the flexible cable by using oil based fiber tip pen as
shown in figure below.
10 X 20mm (3)
1
1 1
1
2
2
5
5
5
3
3
3
4
5
4 4
4 4
10 X 40mm (1)
5 X 40mm (2)
10 X 200mm (2)
985mm
905mm
735mm
625mm
35mm
J671
J453
J452 J561
FLEXG2
FLEXG1
Flexible cable
5 X 20mm (4)
Face up where character is printed.
Affix to
the reverse side. Affix to the front side.
Remove the protection labels for these double-sided
adhesive tapes when installing the flexible cable to the Y bar.
Remove these three protection labels for these double-sided
adhesive tapes after connect the flexible cable to
the connector J671 and J561.
Prepare following size of the double-sided adhesive tapes.
Affix those pieces of double-sided adhesive tapes to the flexible cables
and the flexible cable guides as shown in figure below.