GRAPHTEC CELITE-50, User Manual

Page: 27 / 128

2-5
Chapter 2 Basic Operations
2.3
Setting the Push Rollers
Adjust the positions of the left and right push rollers to suit the width of the media.
Set the push rollers positioned onto both edges of the media.
Moving the Push Rollers
Push Roller
Positioning Groove
Click
To move the push rollers, raise the media set levers and release the
push rollers. Squeeze the "PUSH" part with your fingers, and then
move the push roller left and right while pressing the "PUSH" part. If
the "PUSH" is in a position that is difficult to press, rotate the roller
so that it can easily be pressed. When the push roller reaches to the
desired position, release the "PUSH" part and place it in the position
where it "clicks" into the positioning groove. After setting the push
roller, move slightly to the left and right without pressing the "PUSH"
part to check that it fits in the positioning groove.
Tool carriage
If the tool carriage obstructs the setting the push rollers, release
the left and right media set levers and slowly move the tool carriage
away. Gently hold the tool carriage from both sides. Holding this at a
different position or forcefully moving it may cause damage. The tool
carriage that has been moved will return to its home position when
the power is turned ON.
CAUTION
Be sure to operate/move the media set lever, push rollers, and tool
carriage when operating the load media menu.
Push Roller Setting Positions
Left Side Push Roller Setting Positions
Align the "media pressing portion" of the push roller with the position of the push roller positioning guide to set
the push roller in place.
Align the push roller to the " " position when using the sheet media or the carrier sheet.
Align the push roller to the " " position when using the roll media.
Push Roller Positioning Guide
Roll Media
Sheet Media/Carrier Sheet
Media Pressing Portion
Right Side Push Roller Setting Positions
Set the "Media pressing portion" of the push roller according to the width of media.
Align the media pressing portion with the markings on the top row for standardized sizes (mm), the middle row
for standardized sizes (inch), and the bottom row for non-standardized sizes or the carrier sheet.
Push Roller Positioning Guide
Standardized Sizes (mm)
Standardized Sizes (inch)
Non-standardized sizes/Carrier Sheet
Media Pressing Portion