GRAPHTEC CE7000-130AP, User Manual

Page: 8 / 260

VI
Operating environment
With regard to changes in the operating environment, we guarantee the precision of our products under the
following conditions:
•
The paper used is Graphtec brand for this machine.
•
The Paper Ready Time and Number of Pre Feeds are the manufactures settings of 180 seconds and 2
times.
•
There are no changes in the storage temperature and humidity levels.
•
If there are changes, the repeatable accuracy is equivalent to 0.1 mm per degree Celsius or 0.3 mm per
10% Relative humidity.
•
The paper is re-set after 5 consecutive page cuts.
•
Each page is removed from the basket after cutting.
•
Connection of a ground wire is required.
* When the ground wire is not connected, the machine may be affected by static electricity.
When using the machine without connecting a ground wire, there may be adversely affected in the cutting
results. Make sure that the machine is grounded.
WARNING
The United States Federal Communications Commission has specified that the following notice must be
brought to the attention of users of this product.
FEDERAL COMMUNICATIONS COMMISSION RADIO FREQUENCY INTERFERENCE STATEMENT
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications. Operation
of this equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
USE SHIELDED CABLES
To comply with FCC Class A requirements, all external data interface cables and connectors must be
properly shielded and grounded. Proper cables and connectors are available from GRAPHTEC’s authorized
dealers or manufacturers of computers or peripherals. GRAPHTEC is not responsible for any interference
caused by using cables and connectors other than those recommended or by unauthorized changes or
modifications to this equipment. Unauthorized changes or modifications could void the user’s authority to
operate the equipment.