2-20
Turnng on the power of the plotter.
Operation
1
Check that the power swtch s turned off. (the " " sde s
pressed down)
2
Connect one end of the provded power cord to the CE6000-
120AP AC lne nlet and the other end to an electrcal socket
of the rated supply voltage.
Supplement
When turnng the power off, wat over 20
seconds before turnng t on agan, otherwse
problems may occur wth the dsplay.
3
Turn on the CE6000-120AP by pressng the "|" sde of the
swtch. LCD on the control panel s lt.
Supplement
The Default Screen wll appear after
purchasng the machne. See "2.5 About
the Default Screen"
P.2-19
for more
nformaton.
Ths screen s descrbed as "default screen"
n ths document.
Settngs such as ntal meda feed speed and
communcaton condtons can be performed.
4
If media has not been loaded, the firmware version number is
dsplayed, followed by a prompt to load meda.
Meda set lever rased
(The push roller s up)
Meda set lever lowered
(The push roller s down)
2.6
Connecting to the Power
