6-12
After turnng on the power or changng pen condton settngs, touch the blade to the meda and adjust the blade
drecton. The Intal Blade Control Poston wll need to be set n order to make sure the area s not damaged and
that the blade properly makes contact wth the meda.
Selectng [2mm BELOW] wll change the Intal Blade Control Poston to 2 mm below the cuttng start pont (2 mm
from the edge of the pont from whch the meda wll be shfted.)
Selectng [OUTSIDE] wll but the Intal Blade Control Poston out of the range of the cuttng area.
Fe
ed d
re
ct
o
n o
f m
ed
a
Fe
ed d
re
ct
o
n o
f m
ed
a
2m
m
Push roller
Intal Blade Control Poston
Settng Pont
(Set as"OUTSIDE")
Cut Start Pont
(Cuttng Orgn Pont)
Intal Blade Control Poston
Settng Pont
(Set as"2mm BELOW")
Cuttng area
CAUTION
Selectng [OUTSIDE] and then changng the expand settng to a postve dgt can damage the markng mat. Also, the Blade
Direction Setting may be not properly initialized.
Operation
Supplement
Perform the settngs n Normal menu.
1
Press the [PAUSE/MENU] key.
MENU screen s dsplayed.
2
Press the [1] key (TOOL).
TOOLS SETTING screen (1/3) s dsplayed.
3
Press the POSITION ( ) key.
TOOLS SETTING screen (3/3) s dsplayed.
6.5
Setting Initial Blade Control Position Adjust
