GRAPHTEC CC300-20 Craft ROBO, User Manual

Page: 21 / 55

2-14 CHAPTER 2. CONNECTION AND PREPARATION
PREFACE
CH 3. CRAFT ROBO CONTROLLER
CH 1. PRIOR TO USE
APPENDIX A
CH 2. CONNECTION AND PREPARATION
INDEX
CONTENTS
CH 4. CUTTING DATA SAVED ON SD CARD
PREFACE CONTENTS CH 1. PRIOR TO USE CH 2. CONNECTION AND PREPARATION
CH 3. CRAFT ROBO CONTROLLER CH 4. CUTTING DATA SAVED ON SD CARD APPENDIX A INDEX
Mountng the blade plunger
Mount the blade plunger that has had its protruding blade length adjusted (by selecting the most
suitable blade adjustment cap) in the Craft ROBO.
Caution
When handling the cutter blade, take care not to cut your hands.
CHECKPOINT
Be sure to grip the tool holder firmly when mounting or removing the blade plunger.
(1) Turn the lock lever to the left (OPEN direction) to loosen the tool holder.
Tighten
Lock lever
Loosen
(2) Firmly insert the blade plunger in the tool holder and then turn the lock lever to the right
(CLOSE direction) to tighten the tool holder.
Plunger
Tool holder
Firmly insert the blade plunger until the underside
of the flange contacts the tool holder.
Front