O
perating Instructions for Hand Pallet Truck
76072170
6
3.2
Technical specifications
Lifting capacity (kg)
2000
2000
2500
2500
3000
3000
Max. fork height (mm)
200 (or 190)
Min. fork height (mm)
85 (or 75)
Fork length (mm)
1150
1220
1150
1220
1150
1120
Total fork width (mm)
450/520/540/685
Individual fork width (mm)
160
Loading wheel diameter (mm)
82x70 (or
74x70) Nylon, Polyurethane
Steering wheel diameter (mm)
200 (or
180) Nylon, polyurethane, rubber
4.
Assembly work
If you have bought the pallet truck in a transport package, there is still some assembly work
to be done. You will need tools (hammer, pliers, wrench, etc.), an axle with hole (105), two
dowel pins (106) (one of which is in the axle (105)). These parts are in a plastic bag on the
drawbar.
Figure 1
WARNING: Insufficient stability and incorrect positioning of the pallet lifter may cause
it to overturn.
4.1
Fixing the hand drawbar to the pump unit
a) Place the drawbar on the pump piston (303), then use a hammer to insert the axle with
hole (105) from the right side into the hydraulic pump and drawbar (see fig. 2).
b) Set the control lever (117 or 120G) to ‘LOWER’, then manually insert the adjusting nut
(104), adjusting pin (103) and chain (102) through the hole in the axle (105) (see fig.
3).
c) Press down the drawbar (110,110B or 111G) and then remove the pin.
d) Move the control lever (117 or 120G) to the ‘RAISE’ position. Then lift the lever plate
(319) with the pin (2) and insert the adjustment pin (103) into the front slot of the lever
plate (319). The adjusting nut (104) remains on the bottom of the lever plate.
Legend:
1. Drawbar
2. Bolt
3. Axle with hole
4. Roll pin
5. Fork housing
