Grandstream Networks UCM6510, User Manual

Page: 223 / 483

P a g e | 222
UCM6510 IP PBX User Manual
Version 1.0.20.31
CALL ROUTES
Outbound Routes
Configuring Outbound Routes
In the UCM6510, an outgoing calling rule pairs an extension pattern with a trunk used to dial the pattern.
This allows different patterns to be dialed through different trunks (e.g., "Local" 7-digit dials through an FXO
while "Long distance" 10-digit dials through a low-cost SIP trunk). Users can also set up a failover trunk to
be used when the primary trunk fails.
Note : UCM6510 supports now 500 Outbound routes.
Go to Web GUI

Extension/Trunk

Outbound Routes to add and edit outbound rules.

Click on "Create New Outbound Rule" to add a new outbound route.

Click on to edit the outbound route.

Click on to delete the outbound route.

On the UCM6510, the outbound route priority is based on “Best matching pattern”. For example, the
UCM6510 has outbound route A with pattern 1xxx and outbound route B with pattern 10xx configured.
When dialing 1000 for outbound call, outbound route B will always be used first. This is because pattern
10xx is a better match than pattern 1xxx. Only when there are multiple outbound routes with the same
pattern configured, users can click on to move the outbound route up/down to arrange
the priority among those outbound routes.
Table 66: Outbound Route Configuration Parameters
Calling Rule Name
Configure the name of the calling rule (e.g., local, long_distance, and etc).
Letters, digits, _ and - are allowed.
Pattern

All patterns are prefixed with the "_".

Special characters:
X : Any Digit from 0-9.
Z : Any Digit from 1-9.
N : Any Digit from 2-9.
" . ": Wildcard. Match one or more characters.
" ! ": Wildcard. Match zero or more characters immediately.
Example: [ 12345 - 9 ] - Any digit from 1 to 9.