Firmware Version 1.0.9.26
UCM6100 Series IP PBX User Manual
Page 139 of 305
SRTP
Enable SRTP for the call. The default setting is "No".
Fax Mode
Select Fax mode for this user. The default setting is “None”.
None: Disable Fax.
Fax Detect: Fax signal from the user/trunk during the call can be
detected and the received Fax will be sent to the Email address
configured for this extension. If no Email address can be found for the
user, the Fax will be sent to the default Email address configured in
Fax setting page under web UI->PBX->Internal Options->Fax/T.38.
Strategy
This option controls how the extension can be used on devices within
different types of network.
Allow All
Device in any network can register this extension.
Local Subnet Only
Only the user in specific subnet can register this extension. Up to
three subnet addresses can be specified.
A Specific IP Address.
Only the device on the specific IP address can register this extension.
The default setting is "Allow All".
Skip Trunk Auth
If enable “All”, users do not need to enter password when making an
outbound call. If
enable “Follow Me”, the user can dial out via follow me
without password.
Codec Preference
Select audio and video codec for the extension. The available codecs are:
PCMU, PCMA, GSM, AAL2-G.726-32, G.722, G.729, G.723, iLBC,
ADPCM, LPC10, H.264, H.263 and H.263p.
BATCH ADD IAX EXTENSIONS
Under Web GUI->
PBX
->
Basic/Call Routes
->
Extensions
, click on "Batch Add Extensions"->"Batch Add
IAX Extensions".
Table 47: Batch Add IAX Extension Parameters
General
Start Extension
Configure the starting extension number of the batch of extensions to be
added.
Create Number
Specify the number of extensions to be added. The default setting is 5.
Permission
Assign permission level to the user. The available permissions are
"Internal", "Local", "National" and "International" from the lowest level to
the highest level. The default setting is "Internal".
