P a g e
|
79
GRP260x Administration Guide
Version 1.0.3.42
call-using headset.
➢
When there is an active call using headset, press HEADSET button to
hang up the call.
➢
When Speaker/Handset is being used in dialing/talking status, press
HEADSET button to switch to headset. Press it again to hang up the
call. Or, press speaker/Handset to switch back to the previous mode.
•
Toggle Headset/Speaker
:
When the phone is in idle, press HEADSET button to switch to Headset
mode. The headset icon will display on the left side of the screen.
➢
In this mode, if pressing Speaker button or Line key to off hook the
phone, headset will be used.
When there is an active call, press HEADSET button to toggle between
Headset and Speaker.
Headset Type
Selects whether the connected headset is normal RJ11 headset, Plantronics
EHS, Jabra EHS, Sennheiser EHS headset.
Always Ring
Speaker
Configures to enable or disable the speaker to ring when headset is used on
"Toggle Headset/Speaker" mode. If set to "Yes", when the phone is in Headset
"Toggle Headset/Speaker" mode, both headset and speaker will ring on
incoming call. The default setting is "No".
Group Listen with
handset
Allow handset to be able to listen when picked up during a call with headset
Group Listen with
Speaker
In a call, phone will display softkey to enable speaker listening when audio
mode is set to handset or headset.
Headset TX Gain
(dB)
Configures the transmission gain of the headset. The default value is -6dB.
Headset RX Gain
(dB)
Configures the receiving gain of the headset. The default value is -6dB.
Enable Headset
Noise Shield
When enabled, the remote party will not hear the environmental noise during
a call using the headset. Choose according to the TX loudness of the
earphone. When the TX loudness of the headset is loud, please select the
"Loud Headset", and when the TX loudness of the headset is soft, please select
the "Thin Headset". "Moderate Headset" is selected by default.
Handset
Handset TX Gain
(dB)
Configures the transmission gain of the handset.
