P a g e
|
48
GRP260x Administration Guide
Version 1.0.3.42
Hangup
initiator hangs up.
The default setting is “No”.
Key as Send
Allows users to configure either the “*” or “#” keys as the “Send” key. Please
make sure the dial plan is properly configured to allow dialing * and # out.
The default setting is “Pound (#)”.
Record Key Default Function
Configure whether to turn the recording function on or off when the "Record"
key is pressed for the first time in a call under this account, and switch
between the two. For example, the SIP server can be configured with the
automatic start call recording function. In this case, Record key default
function needs to be configured as "Record off".
Call Recording On
Configures the DTMF sequence sent when pressing the Record key during
a call on this account. Toggles between this value and the off code if possible;
otherwise always sends this code.
Call Recording Off
Configures the DTMF sequence sent when pressing the Recording key
during a call on this account when turning recording off.
Enable Recovery on Blind
Transfer
Enable recovery to the call to the transferee on failing blind transfer to the
target. The default setting is “Yes”.
Notes:
1) This feature only applies to blind transfer.
2) This feature depends on how server handles transfer. If there is any
NOTIFY from server, this feature will not take effect. If server responds 4xx,
phone should try to recover regardless of this option.
3) During blind transfer, after transferor received 200/202 for REFER, but
there is no NOTIFY from server after 7 seconds, transferor will decide to
recover the call with transferee or not depending on the options. This is the
only case that this option will be applied.
Blind Transfer Wait Timeout
Configures the timeout (in seconds) when waiting for sipfrag response in
blind transfer. Valid range is 30 to 300. Default setting is “30”.
No Key Entry Timeout
Configures the timeout (in seconds) for no key entry. If no key is pressed
after the timeout, the collected digits will be sent out. The default value is 4
seconds. The valid range is from 1 to 15.
Ring Timeout
Configures the timeout (in seconds) for the phone to ring when an incoming
call is not answered. Valid range is 30 to 3600. The default setting is 60.
Refer-To Use Target Contact
If set to "Yes", the "Refer-To" header uses the transferred target's Contact
header information for attended transfer.
RFC2543 Hold
Allows users to toggle between RFC2543 hold and RFC3261 hold. RFC2543
