grandimpianti GH6, Installation, Maintenance And User Manual

Page: 150 / 204

Positioning the washing machine
The washing machine can be installed as a built-in
or freestanding unit. Position the machine so that
the electrical plug is easily accessible.
A. Built-in
The washing machine can be installed under a
counter top with a working height of 850-900 mm.
Leave a 5 mm space around the entire machine,
including between the rear edge of the top cover
and the wall behind it.
B. Freestanding
The washing machine can be positioned beside
or under a tumble dryer.
Adjusting the feet
Keep the noise that the machine produces to a
minimum by adjusting the feet so that the machine
is steady and balanced on the floor. Tighten the
lock nuts.
Locking nut
Connection to water supply
Water connection should be carried out by an
appropriately qualified person. Connect the
machine using the accompanying supply hose.
Water pressure should be 0.1–1MPa (approx.
1–10kp/cm
2
; 10–100N/cm
2
). There should be a
stopcock on the water pipe.
If the pipes are newly installed, it may be wise to
flush them through so that any dirt is washed
away. Otherwise, dirt can clog the filter in the
machine’s water intake and cut off the water
supply.
Use only the supply hose supplied with the
machine. Do not re-use old hoses or other loose
supply hoses.
Water intake
At the factory, the machine is set to take in a
mixture of hot and cold water. The machine can
be set for cold water intake only. This setting must
be made by a qualified professional. Contact the
service division.
21
Installation
Part 2 Serial number < B0005202999