grandimpianti GH6, Installation, Maintenance And User Manual

Page: 147 / 204

Error messages
If an error occurs during the programme a
message is shown on the display. To exit the
message after taking measures, turn the machine
off and then back on.
The error messages that may be shown in the
display are:
Close the door
Close the washer door and the programme will
start.
Overfilling
1. Shut off the water tap.
2. See "Drainage error".
Drainage error
Check:
• that no objects are stuck in the drainage hose
outlet.
• that the drainage pump is not blocked by
foreign objects. Clean the pump. See the "Care
and cleaning" chapter.
• that there are no kinks in the drainage hose.
Press the Door opening button (key symbol) to
empty the machine of water before opening the
washer door. If this does not resolve the problem,
call the service division.
Water inlet fault
Check:
• that the tap on the water pipe is open.
• that the filter in the machine’s water intake is
not blocked.
Action:
1. Shut off the water tap.
2. Unscrew the hose.
3. Clean the filter in the intake valve on the
machine.
4. Screw the hose back on.
5. Turn on the tap.
6. Run the program again to check if the fault is
fixed.
7. If this does not resolve the problem, call the
service division.
Door opening error
Call the service division!
Motor fault
Call the service division!
18
Troubleshooting
Part 2 Serial number < B0005202999