23
Operating with Control Software
You can use
HDMI over IP console
control software to manage and control
the connected devices. You just need to extract the provided compression file
to your computer and double-click HDMIoverIPConsole.exe to start it without
additional
installation processing.
This section takes
HDMIoverIPConsoleV2.4.13
as an example.
Before Using the Control Software
Before using the control software, you need to set a static IP address on your
computer and configure your operating system firewall to allow this software
to communicate on your network.
Note:
The operation system must be Windows XP or a later version.
Setting a Static IP on Your Computer
Before using the control software, make sure that the IP address of your
computer installed with this software and TX/RX are in the same network
segment. By default, TX/RX uses AutoIP protocol, and their IP address is
169.254.X.X and subnet mask is 255.255.0.0.
A computer running Windows 7 is used as an example to configure a static IP
address.
1. Click
Start
menu, choose
Control Panel
>
Network and Internet
>
Network and Sharing Center
>
Change Adapter Settings
, right click
Local Area Connection
, and then choose
Properties
.
Summary of Contents for N373
Page 1: ...Version V1 0 1 User Manual N143 N373 N383 Presentation Switcher H 264 Encoder and Decoder ...
Page 47: ...45 2 Right click MX153 to display the shortcut menu ...
Page 57: ...55 3 Configure the intersection between TX and RX in different cells in the Scene area ...
Page 60: ...58 5 Right click on any cell and choose Combine to display the Video Wall Properties window ...
