BEFORE OPERATING YOUR CRAFT
43
D600 Drive/Active/Lux Owner’s Manual
3.
BEFORE OPERATING YOUR CRAFT
CHECKLIST BEFORE DEPARTURE
Using a pressure gauge, check inflation pressure in each section of the tube (gauge not supplied).
Check the tightness of the outboard motor clamps or bolts.
Inspect the steering system: an improperly maintained system may fail, causing sudden loss of
control.
Remove the cockpit drain plug, check the gasket, replace if necessary.
Check the fuel system.
Top off fuel and lubricating oil levels to required levels. Note: do not overfill fuel tank.
Be sure that you do not exceed the recommended maximum load indicated on the Builder’s
plate. Check the load is evenly distributed.
Make sure that each passenger is seated or has a seat available. Inform all passengers regarding
the necessity to hold on to safety handles. Check that each passenger has his personal flotation
device.
Check that all required safety equipment is on board (horn, first aid kit, waterproof light, cell
phone in watertight case, fresh water reserve etc.).
Check that the boat is equipped with an additional flotation device for emergency use.
Check that the boat is equipped with two oars/paddles. Check the condition of the oars and
rowlocks.
Be sure that the boat is equipped with at minimum 2 x boat length of suitable towing line.
Summary of Contents for D600 Drive
