38
V INSTALLATION
EN
Installation, unpacking the product:
Check if there is any damage to the product.
Transportation damage should be immediately reported to the shipping company.
If you notice any damage please report to the seller.
Do not allow children to play with packing material!!!
Installing the support bracket
There are 2 L shaped support brackets to install your product, provided with screws. Fix brackets on
the product body using M5 x 35 screws into M5 turn screws (figure 3a).
a) M5 x 35 YSB
b) L shaped support brackets
Install plastic duct
Mount plastic duct on top of motor compartment using 3,5x9,5 screws (figure 3b).
Drill mounting holes Ø 6 mm
Attach mounting template on the wall and drill holes at points marked as A,B,C using Ø8 mm drill bit.
To install enclosure, use driller by taking reference of min./max. height dimensions (figure 3c).
WARNING : During drilling of the hanging holes, pay attention to the diameter of the holes to be used
for hanging the hood. If the diameters of hanging holes are not as indicated, the hood cannot be
assembled properly.
Wall plugs
Drive Ø10 mm wall plugs into Ø8 mm A,B,C holes. Place Ø6 mm wall plug in two Ø6 mm holes (Figu-
re 3d). Drill holes at points marked as G,H and drive Ø10 mm wall plugs in them.
a) 10 mm Plastic wall plug
b) 6 mm Plastic wall plug
c) Outlet Connection Holes Ø 6 mm
d) Hood hanging holes Ø 8 mm
Enclosure support bracket screws;
Drill holes in the wall using a Ø6 mm drill-bit. Fix the enclosure support bracket using 3,9 x 22 Ysb
screws and Ø6 mm plastic wall plugs. Drill holes in the wall using a Ø10 mm drill-bit. Fix 2 pcs of 5,5
x 60 Ysb screws at A,B points in Ø10 mm plastic wall plugs. The screws should protrude from the wall
about 5 mm (Figure 3e).
a) 5,5 x 60 Ysb Screw
b) 3,9 x 22 Ysb Screw
placing cooker hood on the wall
Hang L shaped support brackets on A and B points (figure 3f)
Tighten the hanging screws:
Using a screwdriver tighten screws to fix the product. You may use the M5x40Ysb screws to make fine
adjustment of hood parallel alignment (figure 3g).
Note: You may make fine adjustments to parallel alignment by easing M5 screws on the top.
Tighten the Hanging Screws:
Fix product onto wall at point C with 5,5x60 Ysb screw in order to ensure your product is safely instal-
led (figure 3h).
Fix product onto wall at point G,H with 5,5x60 screws in order to ensure your product is safely installed
(figure 3i)
Installing aluminium flexible duct:
Connect aluminium flexible duct to outlets on the product and kitchen wall.
Please make sure that this connection is strong enough not to break when the hood operates at
highest fan speed (figure 3j).
Summary of Contents for EFV 3250-90 X
