GF8900-1-INS-LAB-RevB09
1
GF8900-1: ECONOMY OVERBED TABLE, NON-TILT
ASSEMBLY & OPERATION INSTRUCTIONS
PLEASE SAVE THESE INSTRUCTIONS FOR FUTURE USE
Note: The most current version of these instructions can be found online at
www.grahamfield.com
Tools needed: Phillips screwdriver,
9
/
16
hex wrench
WARNING: Important! Read and understand these instructions before assembling or using
the GF8900-1 Overbed Table. If you do not understand any part of these instructions, contact
a healthcare professional for direction in the use of this product. If the GF8900-1 Overbed
Table is not properly assembled and adjusted, personal injury and/or damage to the Overbed
Table could result.
WARNING: If components are damaged or missing, contact your dealer immediately. DO NOT
use substitute parts. Use only Lumex replacement parts. Non-Lumex replacement parts
could cause personal injury and/or damage to overbed table.
WARNING: GF Health Products, Inc. assumes no responsibility for any damage or injury
caused by improper assembly or use of this product.
UNPACKING
1. Check for obvious damage to the carton or its contents. If damage is evident, notify the carrier and
your Graham-Field
®
authorized distributor.
2. Remove all loose packing from the box. Carefully remove all the components from the carton. Com-
ponents: Table top, mast, 6 sheet metal screws, base, 4 casters, 2 hex head bolts, 2 flat washers,
and 2 metal spacers.
ASSEMBLY (SEE PICTURES AT RIGHT)
WARNING: Do not remove the transit lock screw from the mast before the table is completely
assembled; the table top could rise suddenly and cause serious personal injury.
WARNING: Do not disassemble the mast; this could cause serious personal injury.
1. Place the table top upside down on work surface.
2. Position the mast above the table
top, oriented as shown at near right.
Place mast mounting plate on table
top, matching mounting plate holes
with table top predrilled pilot holes.
3. Mount mast to table top: Install sheet
metal screws through mounting plate
holes into table top holes. Tighten.
4. Place the base upside down on work
surface. Press casters into sockets
in bottom of base as shown at lower
right.
5. Place the table top upside down on
work surface. Place the base upside
down above the mast, oriented as
shown at far right.
6. Install the two hex head bolts
through the washers, spacers, and
base, and into the end of the mast
column as shown. Tighten the bolts.
install mast
release
paddle
sheet metal screw
(6 each)
mounting plate
table top
mast
caster
(4 each)
base
install casters
hex head bolt
(2 each)
spacer (2 each)
mast column
washer (2 each)
base
table
install base
transit lock screw
