750000-INS-LAB-RevA08
9
Static function switch
: Press the
static function switch
to
suspend alternating function, if needed; the pressure inside
the air tubes will then be adjusted to identical pressure.
Press the static function switch again to change back to al-
ternating mode. The static function switch toggles between
static and alternating modes.
Main power switch
: The main power switch toggles be-
tween ON and OFF. When power is ON, either the normal
or low pressure indicator illuminates.
InstallatIon
unpaCkIng
1. Before unpacking, check for obvious damage to the car-
ton or its contents. If damage is evident, please notify
the carrier and your Graham-Field equipment provider.
2. Remove all loose packing from the carton.
3. Carefully remove all components from the carton.
4. Inspect all components. If damage is evident, please
notify the carrier and your Graham-Field equipment
provider.
pump and mattress InstallatIon
1. Remove all sheets, blankets, and pillows from the bed.
2. Place the mattress on top of
the bed frame; ensure that
the foot end symbol faces
up at foot end as shown at
right.
3. Fold open the wire hangers
on the back of the pump as
shown at right.
4. Either hang the pump on the bed's
foot end as shown at right, or
