1
750000-INS-LAB-RevA08
the patient's buttock area; your fingers should just fit. If the
fiit is too loose, decrease the setting. If your fingers do not
fit well, increase the setting two notches firmer. Wait ten
minutes and then check again. You should only have to ad-
just this setting one time per patient. Please consult your
physician for an appropriate setting.
quICk dIsConneCt
Pull the power plug from the wall connector to disconnect
the device quickly.
transport Cap
In case of power failure or transport:
Disconnect the quick connector and
cap the mattress with the transport
cap to slow deflation.
Cpr funCtIon
If CPR must be performed on the
patient while the mattress is in use,
to immediately deflate the mattress,
either:
1. Pull the CPR valves from the
mattress in the location of the
arrow shown at right, or
2. Disconnect the quick connector
from the pump in the location of
the arrow shown at right.
maIntenanCe
CleanIng
Perform the following cleaning procedures before use.
Pump
: Wipe the pump with a clean, damp cloth and mild
detergent, and keep it away from dust. Air dry.
quick connector
transport cap
