LX_574G-INS-LAB-RevE21 6
ASSEMBLY
UNPACKING INSTRUCTIONS
Unpack and inspect contents for shipping damage or missing parts. If parts are damaged or
missing, contact your Lumex distributor immediately.
ASSEMBLY INSTRUCTIONS
Back to Frame Assembly
(Refer to Picture at Right)
1. Remove the one-piece back assembly from
the unassembled chair and set it aside.
2. Slide the back assembly into the lower
frame assembly square tubes as shown so
that the back holes line up with the lower
frame horizontal brace holes.
3. Raise the position stabilization bar and
adjust back assembly position until lock
release button positively engages position
stabilization bar link middle slot when chair
is in storage position.
4. Insert screws through horizontal brace
holes and tighten all screws with
screwdriver.
WARNING: Ensure the top screw on each
side of the back assembly square tubing
is completely secure before using recliner.
holes with screws
position
stabilization bar
locking pin
one-piece
back assembly
lock release button
armrest
lower frame assembly
square tube
padded push handle
padded back
holes in back assembly
Back to Frame Assembly