WARNING: For complete operation and safety information, refer to the
EPC500ST
Procedure Chair Operation Manual
, available at www.hausted.com.
WAKE PENDANT
The pendant will go into
SLEEP MODE
after five minutes of no activity — before
pressing the desired function button, press any button to first wake up the pendant.
LOCK ALL
FUNCTIONS
Press and hold LOCK button for three seconds to lock all functions. After five
LED flashes, all four
UP
LEDs illuminate steady green, indicating they are now
locked; an audible signal also indicates when locked and beeps up to three times
until LOCK button is released.
UNLOCK
ALL
FUNCTIONS
Press and hold LOCK and BATTERY buttons for one second to unlock all
functions. A quick LED flash indicates they are now unlocked; an audible signal
also indicates when unlocked.
UNLOCK
INDIVIDUAL
FUNCTION
Press and hold LOCK button and press each
UP
button to unlock each function
individually. As each button is released, its LED will go out, indicating that
function is unlocked.
BATTERY
When the battery discharges to 20% capacity or less, a continuous beep sounds
during motor operation, the LED above the
BATTERY
button illuminates steady
green, and the control box LED illuminates amber.
LOCK /
UNLOCK
BRAKE
Press the
BRAKE
button to lock or unlock all four caster wheels (toggle brakes on / off).
Note: To prevent unintended movement, brakes lock automatically after chair is
stationary for 30 consecutive seconds.
STEER
MODE
Press the
STEER MODE
button to toggle
STEER LOCK
position on / off. When
STEER
LOCK
position is on, all four caster brakes will unlock, and foot-end casters will remain
straight so that chair steers in a straight line.
Note: STEER MODE can be engaged even
if brakes are locked.
EXTEND CHAIR
LENGTH — BUT
FIRST, SUPINE
To extend chair length, first press and hold the
SUPINE
button until the
chair is completely horizontal.
EXTEND CHAIR
LENGTH
Then, at foot end, press and hold the black toggle button below the
EXTEND
label, shown at left.
Note: The motorized leg extension can only
be extended when the leg is in the horizontal position.
CHAIR
POSITION — BUT
FIRST, RETRACT
Before transitioning to
CHAIR
position, retract chair length: at foot end,
press and hold the black toggle button below the
RETRACT
label, shown at
left.
Important: Hold this button until the chair length retracts completely.
CHAIR POSITION
Press and hold the
HOME
button to transition to
CHAIR
position. The
chair automatically raises back section, lowers leg section, and tilts seat
section simultaneously; chair also automatically adjusts height. No LED.
Note: The leg extension must first be fully retracted; if not, the HOME
button will beep when pressed, but nothing will move.
TRENDELENBURG
POSITION
Press and hold the
TRENDELENBURG
button to transition to
TRENDELENBURG
position. The chair automatically lowers back section,
raises leg section, and tilts seat section backward simultaneously; chair
also automatically adjusts height. No LED.
Reverse
Trend
REVERSE
TRENDELENBURG
Press and hold the
REVERSE TRENDELENBURG
button until desired
position is achieved. Chair automatically lowers back section, raises
leg section, and tilts seat section forward simultaneously; chair also
automatically adjusts height. No LED.
HP_EPC500ST-QSG-GF2200009-RevA22
EPC500ST PROCEDURE CHAIR: QUICK-START GUIDE
SAVE THESE INSTRUCTIONS FOR FUTURE USE
