WARNING: Important! Read and understand these instructions before
installing or using the Positioning Belt. If the Positioning Belt is not
properly installed, personal injury and damage to the Positioning Belt
could result.
WARNING: If components are damaged or missing, contact your GF
authorized distributor immediately. DO NOT use substitute parts. Use
only Everest & Jennings replacement parts. Non-Everest & Jennings
replacement parts could cause personal injury and damage to the
Positioning Belt.
WARNING: Cancer and Reproductive Harm -
www.p65warnings.ca.gov
.
WARNING: GF Health Products, Inc. assumes no responsibility for any
damage or injury caused by improper assembly, installation, or use of
this product.
TOOLS REQUIRED: 5/16" (8mm) wrench (not included)
INTENDED USE
This product is intended as a Positioning Belt only.
WARNING: This product is not intended for use as a transport
safety device.
INSTALLATION (SEE STEPS AT RIGHT)
1. Remove seat pad and anti-tippers. Tip chair back until it is resting on its rear
wheels and backrest handles.
2. Insert carriage bolt (part included) through square holes located on the top
of the seat pan and through the hole at the end of positioning belt.
3. Use a 5/16" (8mm) wrench (not included) to securely tighten the nut (part
included) below the seat pan.
4. Tip chair back up to its front casters and reinstall anti-tippers and seat pad.
Length Adjustment
Adjust belt length by loosening or tightening the unsecured belt end on each
side of the buckle; both sides of the belt should be of equal length. The fit
must be snug, but not so tight that comfort or breathing is compromised. You
should be able to slide your open hand between the belt and the wheelchair
user.
WARNING: Ensure Positioning belt is properly adjusted, and
Positioning Belt and mounting bolts are securely installed before
use (3).
OPERATION
To lock the belt, press the push button and slide the latch into the buckle
until it clicks into place. To unlock the belt, press the push button and slide
the latch out from the buckle.
MAINTENANCE AND CLEANING
WARNING: If signs of wear appear, replace the Positioning Belt.
WARNING: Check the Positioning Belt mounting bolts monthly and
tighten as needed.
s
NOTICE: Do not use corrosive cleansers to clean this product.
Clean the Positioning Belt as needed with a mild soap and water solution.
#1
#2
#3
#4
EJ_PT300-505-INS-LAB-RevA22
1
www.grahamfield.com
PT300-505 POSITIONING BELT, PUSH-BUTTON STYLE: INSTALLATION
AND OPERATION INSTRUCTIONS
SAVE THESE INSTRUCTIONS FOR FUTURE USE
