3 0 6 B
I M I N I
8–4
M
AIN
C
IRCUIT
B
REAKER
There is a 50 amp circuit breaker located in the panel beneath the battery select switches. This
breaker is the main protection for the wiring supplying power to the accessory switch panel and
helm fuse block. If this breaker is tripped, depress the red button on the breaker box to reset it.
A
CCESSORY
O
UTLET
- 12 V
OLT
The two 12-volt outlets on either side of the control cable chase on the console provide easily
accessible power supplies for accessories such as cellular phones and spotlights.
C
OMPASS
The compass is located at the helm in direct view of the operator when navigating the boat.
Compensation adjustments may be made by following the instructions provided in the “Owners
Packet”.
A
FT
R
IGGING
C
OMPARTMENT
The rigging compartment is located aft of the fuel tank compartment. This area is functional
for rigging ignition protected accessories and for better access to the rigging components located
aft of this compartment. This compartment contains two flats in the hull bottom for mounting
transducers.
B
ILGE
P
UMP
W
ITH
F
LOAT
S
WITCH
Your boat is equipped with automatic float switches adjacent to the bilge pumps. A float
switch will enable the bilge pump to come on automatically if a significant amount of water
accumulates in the bilge. These switches are wired directly to the batteries. They function
independently of the battery select switches and can activate the bilge pump with the battery
select switches in the “off” position. Batteries should be inspected frequently to ensure proper
operation. The bilge pumps are also equipped with switches at the helm. When a switch is in the
“off” position, the pump is off unless activated by the float switch.
B
ILGE
P
UMP
L
OCATION
There are two bilge pumps on the 306 Bimini. One is located under the motorwell access plate
forward of the transom. The other is located under the rectangular access plate in the lower
console rigging area.
N O T I C E
These outlets cannot be used with a cigarette lighter.
N O T I C E
The rigging hatch and mounting screws must be sealed with silicone sealer after rigging is
complete. When the lid is removed, it must be resealed to insure watertight integrity.
C A U T I O N
To prevent damage to the bilge pump, do not run it dry for a prolonged period of time.
!
