Grady-White Boats Freedom 375, Owner'S Manual, Page: 76 / 86

8-22
Chapter 8: Freedom 375
USB Charging Outlets
Your boat is equipped with three USB charging outlets. They are located inside the cabinet in
the port cabin, forward of the starboard deckwing insert, and next to the stereo on the port console
panel. These outlets provide easily accessible power supplies for charging accessories such as cell
phones and tablets.
Vacuflush
®
Head System
The VacuFlush
®
Head consists of a vitreous china bowl, vacuum pump with tank, and a holding
tank. To operate the head, the head and freshwater switches on the DC panel must be in the “on”
position. This provides power to the vacuum pump, and pressurizes the freshwater system. Since
this unit uses freshwater, it is not necessary to open a seacock prior to use. Instructions on the
operation of your VacuFlush
®
head are as follows:
1. Verify that the switches on the DC panel are in the “on” position.
2. To add water prior to flushing, raise the flush lever on the bowl until the desired level is
reached.
3. To flush, depress the flush lever swiftly until contents clear the bowl. A sharp popping
noise is normal when the vacuum seal is broken and flushing begins. Be sure to hold the
lever down for 3 seconds.
N OT I C E
Do not dispose of sanitary napkins or other non-dissolving items in the toilet. Also, do not
attempt to flush facial tissue, paper towels, or large quantities of toilet paper.
Emptying Vacuflush® Head Holding Tank
Located on the bottom of the AC/DC panel is a monitor which displays the fill level of the holding
tank When the tank is filled, it can be discharged overboard or emptied through the deck pump-out
fitting. Following are instructions on both operations:
Deck Pump-out
1. Remove the cap from the deck pump-out fitting located on the starboard gunwale.
2. Connect a vacuum hose from a pump-out station to the deck fitting and run until the tank
is empty.
3. Replace the cap on the deck pump-out fitting.
Overboard Discharge
1. Open the discharge seacock by pulling up on its remote seacock arm located in the helm
storage compartment. This seacock must be open prior to discharge to prevent damage
to the discharge pump.
2. Place the “Head” and “Hold Tank Discharge” switches on the DC panel in the “on”
position.
3. Engage the pump using the key switch in the holding tank monitor. Turn the switch to the
“START” position. The discharge pump will run until the tank is empty.