Grady-White Boats Freedom 325, Owner'S Manual, Page: 68 / 80

8-16
Chapter 8: Freedom 325
Trim Tab Pump Location
The trim tab pump is located in the lower helm rigging area, and can be accessed through the
lower panel in the starboard console. The hydraulic fluid levels should be checked on an annual
basis or anytime there is evidence of a leak.
USB Charging Outlets
Your boat is equipped with three USB charging outlets. They are located in the port and
starboard deckwing inserts, and inside the port console next to the stereo panel. These outlets
provide easily accessible power supplies for charging accessories such as cell phones and tablets.
Vacuflush
®
Head System
The VacuFlush
®
Head consists of a vitreous china bowl, vacuum pump with tank, and a holding
tank. To operate the head, the head and freshwater switches on the DC panel must be in the “on”
position. The head switch provides power to the vacuum pump. The freshwater switch pressurizes
the freshwater system. Since this unit uses freshwater, it is not necessary to open a seacock prior to
use. Instructions on the operation of your VacuFlush
®
head are as follows:
1. Verify that the switches on the DC panel are in the “on” position.
2. To add water prior to flushing, raise the flush lever on the bowl until the desired level is
reached.
3. To flush, depress the flush lever swiftly until contents clear the bowl. A sharp popping
noise is normal when the vacuum seal is broken and flushing begins. Be sure to hold the
lever down for 3 seconds.
N OT I C E
Do not dispose of sanitary napkins or other non-dissolving items in the toilet. Also, do not
attempt to flush facial tissue, paper towels, or large quantities of toilet paper.
Emptying Vacuflush
®
Head Holding Tank
Located on the wall above the sink in the port console is a monitor which displays the fill level of
the holding tank. When the tank is filled, it can be discharged overboard or emptied through the
deck pump-out fitting. Following are instructions on both operations:
Deck Pump-out
1. Remove the cap from the deck pump-out fitting located on the port gunwale.
2. Connect a vacuum hose from a pump-out station to the deck fitting and run until the tank
is empty.
3. Replace the cap on the deck pump-out fitting.