Priming
30
313875J
Priming
1.
Place waste containers below both ratio check dis-
pense valves.
NOTE:
Both ratio check dispense valves will be open
when dispensing in Prime Mode. Only one pump moves
but material may drip from the other ratio check dis-
pense valve when opened.
2.
Verify RAM director valve is in the DOWN position
and air pressure is applied to the RAM.
3.
Press
repeatedly to select Prime Mode then
press
to accept.
4.
Check the dispense settings shown at the bottom of
the screen.
5.
If desired, change the dispense settings.
a.
Press
to enter editing mode.
b.
Use the left and right arrow keys to select the
item to change.
c.
Use the numeric keypad to type the new value.
d.
Press
to accept the new value.
e.
Press
to exit editing mode.
6.
Press
to select the A (Red) side.
7.
Press
to begin dispensing A (Red) material.
8.
Continue dispensing until clean, air-free material is
dispensed from both sides then press
to stop
dispensing.
9.
Press
to select the B (Blue) side.
10. Press
to begin dispensing B (Blue) material.
11. Continue dispensing until clean, air-free material is
dispensed from both sides then press
to stop
dispensing.
Summary of Contents for VPM 12
Page 9: ...A Red and B Blue Components 313875J 9...
Page 50: ...Maintenance 50 313875J...
