Connect
Connect
Connect the
the
the CAN
CAN
CAN Cables
Cables
Cables
Connect the Control Area Network (CAN) cables to
the control interface (42) so that the interface can
communicate with the isolation system (1).
1.
Connect the power supply CAN cable:
a.
Locate the CAN cable attached to the power
supply (47) on the back of the cabinet.
b.
Screw the cable into the bottom fitting on
the right side of the cabinet, next to the light
tower.
Figure 17 Controller CAN Cable Connections on
the Cabinet (no Color Change)
2.
The system is equipped with another CAN
cable (43) that is used to connect to the control
interface:
On
On
On systems
systems
systems that
that
that are
are
are not
not
not color
color
color change
change
change enabled:
enabled:
enabled:
a.
Screw one end of the cable (43) into the
fitting on the right side of the cabinet.
b.
The bottom of the controller contains two
fittings. Screw the other end of the cable (43)
into the fitting as shown below.
Figure 18 Connections on the Control Interface
(Systems without Color Change)
On
On
On systems
systems
systems that
that
that are
are
are color
color
color change
change
change enabled:
enabled:
enabled:
a.
Screw cable (611) into C4 on the color
change module. See the parts figure in
Color Change Kit 26B415, page 128
and
Color Change: Pneumatic and Wiring
Connections, page 112
b.
Connect C5 from the color change module to
the control interface.
3.
Insert the controller into the bracket (41) on the
top of the cabinet.
To mount the controller in another location, remove
bracket (41) from the system and mount it in
a convenient location. For information about
available alternate length CAN cables, see
3A8493A
23
