Operation
3A7467C
25
Use the Wash Feature
The wash feature uses water (without abrasive) to rinse
areas that have been blasted with abrasive. It is also a
convenient feature for flushing abrasive from the blast
hose.
1. Close the abrasive ball valve (M).
2. Turn the selector valve to WASH.
3. Blast 1-2 minutes until the abrasive is cleared from
the hose.
4. The equipment is now ready to wash any previously
blasted surfaces.
NOTICE
There will always be some residual abrasive in the
blast hose. Never use the wash feature on any
surface other than where you have blasted, or intend
to blast. It will affect/dull the surface.
NOTICE
Do not use the wash feature on wood that has been
blasted. It could damage the wood and cause the
grain to rise. Wait for the wood to dry and then use a
broom, brush, or vacuum to remove any residual
abrasive.
WLD
M
WLD
WLD
Summary of Contents for EcoQuip 2 EQ200t Elite
