Graco E-Flo iQ, Operation Manual

Page: 38 / 102

Operation
38 333587B
Operation
Ram Run Screen
1. Toggles between two modes of control: Local and
Remote. See
Control Modes
on page
40
.
2. Select to enter or exit the editing mode for the
screen.
3. Indicates whether or not an error is active on this
pump and the pump status. See
Pump Status
on
page
40
.
4. Displays the current pump pressure.
5. Displays the current dispense valve pressure.
6. Shows the status of the dispense valve. Green is on,
gray is off.
7. Used to run beads manually. This is only available
when the system is in Local mode. See
Manual
Pump Operation
on page
40
.
8. Select to enter or exit drum depressurization mode.
See
Depressurization Mode
on page
40
.
9. Select to enter or exit dispense valve
depressurization mode. See
Depressurization
Mode
on page
40
.
10. Select to enter or exit priming mode. See
Priming
Mode
on page
41
.
11. Displays the Actual amount of material.
12. Displays the current flow rate.
13. Displays the name of the style that you have
assigned. See
Style Screen 1 - Style Definition
on
page
24
.
14. Shows the Style identification number that is
currently in use. See
Style Screen 1 - Style
Definition
on page
24
.
15. Displays the size of the pump.
16. Shows the status of the Platen valve used during
pump depressurization. Green is on, gray is off.
17. Displays the current mode of control (Local or
Remote). See item 1.
NOTE:
The pump and material line show animated
operation and material flow when dispensing.
1
7
6
5
4
3
2
8
11
10
9
16
15
14
13
12
17