Graco E-flo iQ 26B543, Installation-Parts

Page: 66 / 80

Kits and Accessories
66 3A8217A
Communication Gateway Module (CGM) Kits
CGM Kits
Installing a CGM Kit
1. Follow the Pressure Relief Procedure on page 36.
2. Verify the power is off to the system.
3. Install the CGM bracket included with the kit to the
ram post bracket with the four 1/4-20 x 0.5 in.
screws included in the kit.
4. Remove the access cover from the CGM (DA).
Loosen and save the two M5-0.8 x 45 mm x screws
(DB), and remove the CGM (DC) from the base
(DD). See F
IG
. 52.
5. Using the four M4-0.7 x 20 mm mounting screws
included in the kit, mount the base (DD) to the CGM
bracket.
6. Reattach the CGM (DC) onto the base (DD) with the
two screws (DB) that were removed and saved from
step 4.
7. Reattach the access cover (DA).
8. Unplug the cable from the ADM and plug the cable
back into CGM (DC).
9. Plug 3.0 m cable (121003) included in the CGM kit
from the CGM to the ADM.
F
IG
. 51: CGM CAN Connections
Part Number Description Heat Option
26B169 CGM Kit, EtherNet/IP Heated
26B170 CGM Kit, DeviceNet Heated
26B171 CGM Kit, PROFINET Heated
26B172 CGM Kit, PROFIBUS Heated
All electrical wiring must be done by a qualified elec
-
trician and comply with all local codes and regulations
CAN Port 1
CAN Port 2
F
IG
. 52: Disassembling the CGM
DC
DB
DD
DA