Setup
333587D
33
NOTE:
When a Level Password is entered correctly, the
ADM will place an even into the event log of the access
level granted.
Advanced Setup Screen 3
Use the ADM directional keypad (BH) to navigate to
Advanced Screen 3. This screen allows you to select
units of measurement, rates, and the type of
temperature scale to use for the operation of your
system.
1. Press the
soft key to enter editing mode.
2. Select between psi, bar, and MPa for the Pressure
Units.
3. Select the Rate between x/min and x/sec.
4. Select the Flow Rate from cc, gal(US), gal(UK),
oz(US), oz(UK), liters, or cycles.
5. Select the Drum Volume from cc, gal(US), gal(UK),
oz(US), oz(UK), liters, or cycles.
6. Select the Temperature between °C and °F.
7. For Enabled Temp Adjustments, use the
key
to select to Enable or Disable temperature
adjustments. Enabling this feature allows you to
change temperature setpoints and setbacks
through the Heat Run screen. See
Heat Run
Screen
on page
.
8. Press the
soft key to save your changes and
exit editing mode.
Advanced Setup Screen 4
Use the ADM Directional Keypad (CH) to navigate to
Advanced Screen 4. The parameters on this screen
pertain to USB downloads.
1. Press the
soft key to enter editing mode.
2. USB downloads automatically begin when a USB
drive is inserted. Use the
key to disable this
feature in the Disable USB Downloads/Uploads
box.
3. If you do not want USB log errors to be generated
on the ADM, use the
key to disable this feature
in the Disable USB Log Errors box.
4. For the Download Depth: Last feature, set the
desired download depth using the keypad and
key to enter the desired number of days. This
specifies how many days worth of pump data will
be kept in the USB logs. Once the logs fill up, the
oldest recording will be overwritten.
5. To enable a time frame range of data to download
upon insertion of a USB drive, use the
key in
the Data Range Prompt Enable box.
6. Press the
soft key to save your changes and
exit editing mode.