Graco 262960, Instructions Manual

Page: 7 / 68

Warnings
3A7467D 7
Warnings
The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The
exclamation point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks.
When these symbols appear in the body of this manual or on warning labels, refer back to these Warnings.
Product-specific hazard symbols and warnings not covered in this section may appear throughout the body of this
manual where applicable.
WARNING
SPECIFIC CONDITIONS OF USE (ATEX systems only)
• Ground all equipment in the work area. See Grounding (ATEX systems only) Instructions.
• All label and marking material must be cleaned with a damp cloth (or equivalent).
DUST AND DEBRIS HAZARD
Use of this equipment can result in the release of potentially harmful dust or toxic substances from the
abrasive being used, the coatings being removed, and the base object being blasted.
•
For use only by sophisticated users familiar with applicable governmental safety and industrial
hygiene regulations.
• Use equipment only in a well-ventilated area.
• Wear a properly fit-tested and government approved respirator suitable for the dust conditions.
• Follow local ordinances and/or regulations for disposal of toxic substances and debris.
PRESSURIZED EQUIPMENT HAZARD
Fluid from the equipment, leaks, or ruptured components can splash in the eyes or on skin an cause
serious injury.
•
Follow the Pressure Relief Procedure when you stop spraying/dispensing and before cleaning,
checking, or servicing equipment.
• Tighten all fluid connections before operating the equipment.
• Check hoses, tubes, and couplings daily. Replace worn or damaged parts immediately.