Setup
3A7398A
9
Setup
Connect GrindLazer to Skid
Steer
The following instructions are generic. Due to the
differences in attachment mounting and attachment
methods among various brands of skid steers, refer to
your skid steer owners manual for attachment
connection instructions specific to your skid steer.
Verify that the hydraulic hoses are clear from the front of
the Universal Quick Attach Mount Plate and that the
mounting plate is free from dirt and debris. When clear,
move the skid steer close to the Universal Quick Attach
Mount Plate. Tilt skid steer plate adapter forward to align
coupling point with the upper part on the Universal Quick
Attach Mount Plate and raise skid steer plate adapter
slightly.
When the top edge of the skid steer plate adapter is
seated in the top part of the Universal Quick Attach
Mount Plate, curl the skid steer tilt function back until the
Universal Quick Attach Mount Plate is flat against the
skid steer plate adapter. Lock down the skid steer plate
adapter levers. Before operating the GrindLazer, verify
that the skid steer lock pins are fully engaged through the
latch slots on the Universal Quick Attach Mount Plate.
Wipe off any dirt or dust from the male and female
Hydraulic Return/Supply Lines with a clean rag before
attaching hoses, to keep contaminants from entering the
hydraulic system. Connect the GrindLazer Hydraulic
Return/Supply Lines to the auxiliary circuit connectors on
the skid steer.
CRUSH HAZARD
To avoid serious injury or death, never work under the
equipment unless it is securely supported by safety
stands or blocks.
Connect Skid Steer to Universal
Quick Attach Mount Plate
Check Skid Steer Lock Pin
Engagement
