Graco 25E202, Instructions Manual

Page: 24 / 46

Installation
24 3A6931A
Pump ADM Kit
The pump ADM kit
25E439
comes fully assembled and
ready to attach to the pump. The mounting holes for the
ADM are located next to the ports for the cable
connections as shown in
Figure 46
.
1. Align the mounting bracket with the mounting holes
on the pump.
2. Attach the ADM assembly using the washers (410),
locking washers (404), and fastener knobs (403).
3. Adjust the ADM to the required angle and tighten
the two knobs until it is secure.
4. Connect the CAN cable (407) to the ADM as shown
in
Figure 47
.
5. Connect the other end of the CAN cable (407) to the
electric driver in Port 1.
6. Install the software as described in the E-Flo SP
Software Instructions. See
Related Manuals
on
page
2
.
Ram ADM Kit
The ram ADM kit
25E437
needs to be attached to the
ADM bracket that is included in each of the ram
conversion kits.
1. Mount the ADM (501) to the ADM bracket on the
ram as shown in
Figure 49
.
2. Connect the CAN cable (502) to the ADM (501) as
shown in
Figure 47
.
F
IG
. 46: Mount ADM to the Pump
F
IG
. 47: ADM CAN Cable Connection
410
404
403
CAN Cable Connection
F
IG
. 48: Electric Driver Port for CAN Cable
F
IG
. 49: Mount the ADM to the Ram
CAN Cable
Connection
501
ADM
Bracket