Set
Set
Set Up
Up
Up E
E
E---Flo
Flo
Flo DC
DC
DC Pumps
Pumps
Pumps
After turning on node communication to each
component, each pump in the system must be
individually configured. (Typically, each station
contains one pump used to circulate fluid throughout
that station.)
Use this procedure to specify the pump installed in
one specific station. If the system contains multiple
stations, use this procedure separately for the pump
in each station.
Figure 66 E-Flo DC Setup Screen
1.
Press
on any Run screen to enter the Setup
menu screen.
2.
Press E-Flo
E-Flo
E-Flo DC
DC
DC.
3.
On the E-Flo DC Setup screen, press the Station
Station
Station
Number
Number
Number field.
4.
On the Station
Station
Station Number
Number
Number keypad, enter the number
of the station to be configured.
The number in the field is the station that is being
configured in the following steps. The station
name is displayed directly below the station
number.
5.
Press each item’s response field and use the
keypad that displays to specify the equipment
used in the selected station. For a list of fields,
see
Fields on the E-Flo DC Setup Screen
.
NOTE: For a newly-created station, all fields read
No
No
No or None
None
None.
6.
Repeat steps 3–5 for each additional pump in the
system.
68
3A4030C
